Advertising:
Difference between revisions of "Engine Electrical"
Jump to navigation
Jump to search
(Created page with "== Engine Electrical == === Glow Plug replacement === [http://www.thesamba.com/vw/forum/viewtopic.php?t=286978&highlight=diesel Glow Plug Replacement] === Alternator 90a Up...") |
|||
| Line 8: | Line 8: | ||
Use a 1985-88 Jetta alternator pulley & 90a Alternator | Use a 1985-88 Jetta alternator pulley & 90a Alternator | ||
| + | |||
| + | === Starter Replacement === | ||
| + | |||
| + | SR28X is the model to search for ideally Bosch | ||
| + | |||
| + | The best instructions I found was via Libby here [http://www.vwdieselparts.com/forum/viewtopic.php?t=9864 here] which states: | ||
| + | |||
| + | ''I would first remove the negative battery cable. Then I would loosen the two starter mounting bolts and remove one of them, leaving the other one just barely in place. Then slide underneath the van with 13mm wrench or socket and ratchet in hand. I can slide under there even without it jacked up, but with it on jack stands or ramps makes it less crowded. Loosen and remove the solenoid nut. Pull the spade connector. Remove the last starter bolt by hand and pull the starter out to the bottom of the van.'' | ||
Revision as of 03:09, 2 October 2015
Contents
Engine Electrical
Glow Plug replacement
Alternator 90a Upgrade
Use a 1985-88 Jetta alternator pulley & 90a Alternator
Starter Replacement
SR28X is the model to search for ideally Bosch
The best instructions I found was via Libby here here which states:
I would first remove the negative battery cable. Then I would loosen the two starter mounting bolts and remove one of them, leaving the other one just barely in place. Then slide underneath the van with 13mm wrench or socket and ratchet in hand. I can slide under there even without it jacked up, but with it on jack stands or ramps makes it less crowded. Loosen and remove the solenoid nut. Pull the spade connector. Remove the last starter bolt by hand and pull the starter out to the bottom of the van.
